Male Header 2.54 90° 40 pins

Male 40-pin 2×20 Header 90°

This 90° 40-pin 2×20 male header can be used on a Raspberry Pi Zero or a pHAT to break out the pins.

You can add the 40-pin 2×20 male 90° header to a Raspberry Pi Zero board to make it compatible with a HAT‘s female header.

You can use it to solder a Pi Zero and pHAT permanently together.

2.54mm pin spacing male header.

You can use the 90° angle male pins version for mounting inside projects at a right-angle or for routing wiring back underneath a HAT where space is at a premium but you don’t want to solder wires directly onto your precious boards.

Note: A good competence at soldering is required before attempting to add a right-angle header, as it is a quite tricky operation.