OmniVESA Panel

OmniVESA: the perfect mounting solution

OmniVESA is a panel and is the ideal mounting solution for your Raspberry Pi board.

Remove the protective packaging and simply follow the assembly instructions below. Your Raspberry Pi can be mounted either on its own or inside one of your favourite cases.

The nylon screws provided are long enough to fit most common cases. If you find that the screws protrude too far from your case, you can simply cut them down. To do this, you’ll need a pair of wire cutters, but remember to protect your eyes when using them.

The OmniVESA panel allows for mounting at distances of either 7.5 cm or 10 cm.

The OmniVESA kit contains

• 1 OmniVESA
• 2 x 16mm knurled nylon M4 (thumbscrew)
• 2 x 5mm nylon spacers
• 2 x M2.5 nylon screws
• 3 x M2.5 nuts

Raspberry Pi without a case: use the included nylon bolts to attach the Raspberry Pi board to the VESA panel. To do this, simply use the mounting holes on the RPI board itself.

Pibow Coupé Royale case for RPI Model A+: attach the base panel of the case, as shown in the photo below, using the included screws.

Pibow case for Raspberry Pi Model A/B/3B+/4B: attach the OmniVESA panel underneath the base panel of the Pibow case, as shown in the photo below, using the screws provided.

Pimoroni name: OmniVESA [PIM011]