JST SH 4-Pin Cable, 400 mm long
You can use this 4-wire cable with Adafruit’s Stemma QT or Sparkfun’s Qwiic connectors. This cable is just over 400 mm (approximately 15.7 inches) long and features 4-pin JST-SH female connectors at both ends. Compared to the larger JST-PH connectors, Qwiic/Stemma QT connectors have a 1mm pitch rather than 2mm, while still providing a secure connection and being easier to plug in and remove.
This JST-SH cable can be used with boards featuring Qwiic and StemmaQT connectors to easily connect sensors and drivers to boards with 0.1″ headers or to breadboards without the need for soldering. Note: When using this cable with Qwiic connectors, the wire colours are as follows:
Red: 3.3VDC power supply
Black: Ground
Blue: I2C Data (SDA)
Yellow: I2C Clock (SCL)
The data wires are interlaced with the ground and power wires to reduce interference (crosstalk). However, you should bear in mind that this cable is relatively long for an I2C connection, so you may encounter problems when using it with signals at 1MHz, 800KHz or even 400KHz. If you experience connection difficulties or data transmission issues, try reducing the I2C clock frequency.
For more information on JST-SH connectors, visit the JST website.
Adafruit name: STEMMA QT / Qwiic JST SH 4-Pin Cable – 400mm long [ADA5385]



























Reviews
There are no reviews yet.